A. MRI Compatible Script Files

In general, MRI scripts aren't of much use with the a.out object file format, since it only has three sections and MRI scripts lack some features to make use of them.

You can specify a file containing an MRI-compatible script using the `-c' command-line option.

Each command in an MRI-compatible script occupies its own line; each command line starts with the keyword that identifies the command (though blank lines are also allowed for punctuation). If a line of an MRI-compatible script begins with an unrecognized keyword, ld issues a warning message, but continues processing the script.

Lines beginning with `*' are comments.

You can write these commands using all upper-case letters, or all lower case; for example, `chip' is the same as `CHIP'. The following list shows only the upper-case form of each command.

ABSOLUTE secname

ABSOLUTE secname, secname, ... secname

Normally, ld includes in the output file all sections from all the input files. However, in an MRI-compatible script, you can use the ABSOLUTE command to restrict the sections that will be present in your output program. If the ABSOLUTE command is used at all in a script, then only the sections named explicitly in ABSOLUTE commands will appear in the linker output. You can still use other input sections (whatever you select on the command line, or using LOAD) to resolve addresses in the output file.

ALIAS out-secname, in-secname

Use this command to place the data from input section in-secname in a section called out-secname in the linker output file.

in-secname may be an integer.

ALIGN secname = expression

Align the section called secname to expression. The expression should be a power of two.

BASE expression

Use the value of expression as the lowest address (other than absolute addresses) in the output file.

CHIP expression

CHIP expression, expression

This command does nothing; it is accepted only for compatibility.

END

This command does nothing whatever; it's only accepted for compatibility.

FORMAT output-format

Similar to the OUTPUT_FORMAT command in the more general linker language, but restricted to one of these output formats:

1. S-records, if output-format is `S'

2. IEEE, if output-format is `IEEE'

3. COFF (the `coff-m68k' variant in BFD), if output-format is `COFF'

LIST anything...

Print (to the standard output file) a link map, as produced by the ld command-line option `-M'.

The keyword LIST may be followed by anything on the same line, with no change in its effect.

LOAD filename

LOAD filename, filename, ... filename

Include one or more object file filename in the link; this has the same effect as specifying filename directly on the ld command line.

NAME output-name

output-name is the name for the program produced by ld; the MRI-compatible command NAME is equivalent to the command-line option `-o' or the general script language command OUTPUT.

ORDER secname, secname, ... secname

ORDER secname secname secname

Normally, ld orders the sections in its output file in the order in which they first appear in the input files. In an MRI-compatible script, you can override this ordering with the ORDER command. The sections you list with ORDER will appear first in your output file, in the order specified.

PUBLIC name=expression

PUBLIC name,expression

PUBLIC name expression

Supply a value (expression) for external symbol name used in the linker input files.

SECT secname, expression

SECT secname=expression

SECT secname expression

You can use any of these three forms of the SECT command to specify the start address (expression) for section secname. If you have more than one SECT statement for the same secname, only the first sets the start address.